Answers are grounded in this paper and cite their sources.
Numerical investigation demonstrates how pillar geometry impacts shear and peel adhesion in PDMS adhesives, suggesting design optimizations.
This study presents a microscale finite element investigation of the effect of pillar diameter and height on shear and peel adhesion in polydimethylsiloxane (PDMS) dry adhesives. Although previous studies have investigated micropillar adhesion properties, the effects of pillar diameter and height on the adhesion behavior are not understood. Three-dimensional 3 × 3 pillar array models are developed in ANSYS with a fixed 5 µm spacing, and pillar geometry is varied systematically to isolate the mechanical effects of diameter (5-15 µm) and height (5-15 µm). The bottom PDMS substrate is fully constrained, while a polyethylene terephthalate plate is displaced laterally or vertically at a rate of 10 µm min⁻¹ to simulate shear and peel loading, respectively. The simulation results show that shear adhesion increases with pillar diameter but decreases with increasing pillar height, whereas peel adhesion decreases with both increasing diameter and height due to stiffness-driven reductions in effective contact area. Equivalent strain contour maps reveal geometry-dependent bending, strain localization, and contact loss, providing direct mechanistic insight into the observed adhesion trends. Although the simulated domain represents a small unit cell, the geometric dependencies agree qualitatively with authors’ recent experimental measurements on larger PDMS adhesive pads, indicating that adhesion is fundamentally governed by the stiffness–compliance balance described by k ∝ Ed⁴/h³ . These findings provide a quantitative, geometry-driven framework for optimizing bioinspired PDMS dry adhesives for applications requiring tunable shear and peel performance.
No takes yet. Share an insight, caveat, or question.
Hassani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: