Key result
3D printed models successfully simulate Amulet occluder implantation for ~$2 per model.
Why the study?
Does a 3D printed model method accurately predict optimal Amulet-type occluder size in patients undergoing left atrial appendage closure?
Cohort (n=33)
Does a 3D printed model method accurately predict optimal Amulet-type occluder size in patients undergoing left atrial appendage closure?
Answers are grounded in this paper and cite their sources.
Patient-specific 3D printed models derived from CT data provide a feasible and low-cost ($2 per model) method for preoperative simulation and sizing of left atrial appendage occluders.
This paper describes the design of a method to simulate the implantation of an Amulet-type occluder using a 3D model of the left atrium appendage. A methodology was developed for the 3D printing of left atrial models followed by simulation of implantation. CT DICOM data for creating the 3D model were obtained from a retrospective cohort of patients with left atrial appendage occluder closure. These data were used to print 3D models, and a simulation of the Amulet occluder implantation was performed on these models. A demo set of all sizes was tested to select the most optimal size. The success of the methodology was verified in all 33 patients. The average left atrial modeling time was 11.3 min, and the average printing time was 4:40 hours. With a resin consumption of 21.2 mL, the average cost per model is $2. The final methodology has become a routine part of preoperative planning in patients prior to left atrial appendage closure, and prospective data will answer whether it contributes to a decrease in operative time, radiation dose during surgery, and number of repositions. Any improvements may contribute to reducing the cost of implantation.
No takes yet. Share an insight, caveat, or question.
Hečko et al. (2023) conducted a cohort in Left atrial appendage closure (n=33). 3D printed model simulation for Amulet occluder sizing was evaluated on Success of the methodology. A 3D printed model methodology for simulating Amulet occluder implantation was successfully verified in 33 patients, with an average modeling time of 11.3 min and a cost of $2 per model.
Synapse has enriched 10 related papers. Consider them for comparative context: