Answers are grounded in this paper and cite their sources.
Examines mechanical behavior of AA1050-B4C composites with various graphene ratios, suggesting optimal levels for performance.
In this study, B 4 C-reinforced composites containing 50% AA1050 matrix and various amounts of graphene nanoparticles were produced using the pressure infiltration method and their tribological properties were investigated. Graphene was homogeneously added to the surface of the micro-sized B 4 C reinforcement at concentrations of 0.25%, 0.50%, and 1% using a vacuum distillation unit. Preforms with a diameter of 7× 45[Formula: see text]mm were prepared using B 4 C powder with a grain size of approximately 48 [Formula: see text]m. The AA1050 matrix was infiltrated into these preforms using the pressure infiltration method at 750 ∘ C and 8 bar. The microstructural properties of the produced composite samples were analyzed using Scanning Electron Microscopy and X-Ray Diffraction tests, while hardness and compression tests were used to determine their mechanical properties. While the hardness of the composites increased with graphene addition up to 0.50%, a decrease in hardness was observed when the graphene addition rate exceeded 0.50%. The compression test results are consistent with the hardness test. Graphene’s lubricating effect increases the wear resistance of the composites up to 0.50% graphene addition, while graphene addition above this level causes porosity, resulting in a decrease in mechanical and wear resistance.
No takes yet. Share an insight, caveat, or question.
Çevi̇k et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: