Answers are grounded in this paper and cite their sources.
Investigates friction and wear behavior in hot work tool steels, suggesting optimal heat treatment processes.
ABSTRACTThe aim of the present work is to investigate the friction and wear behavior of commercial hot work tool steels. It is planned to get optimal combination of hardness, friction coefficient and wear by various heat treatment processes and tempering temperatures. Quenching, tempering, martempering and finally austempring treatments were applied to the tested steels. The hardness (HRC) of the steels after heat treatment was determined to evaluate the surface resistance to wear. Scratch test was carried out using a diamond stylus of specified geometry along a straight line path under dry sliding condition. Friction coefficient was calculated to give specific information about surface tribological property. Wear scar width as a measure of wear was measured using optical microscope. It was found that the highest values of hardness and friction coefficient were observed for tested specimens that heat treated at salt bath at 250°C quenched and normalized. Maximum wear was displayed by as received specimens, while the minimum wear was shown by tested specimens that treated in salt bath at 500°C quenched and normalized. The highest value of hardness was observed for the test specimens that tempered at 500°C Tested specimens tempered at 700°C showed higher wear than that observed for tested specimens tempered at 500°C and 600°C. The test specimens quenched by air compressed and tempered have the highest values of hardness (43.2 HRC and 42.5 HRC) respectively.
No takes yet. Share an insight, caveat, or question.
Tawfik et al. (2014) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: