Answers are grounded in this paper and cite their sources.
Evaluates heat flux modelling accuracy in sunflower and wheat crops, suggesting the importance of leaf angle.
The two-source energy balance model pyTSEB-PT was used to model latent heat fluxes from sunflower and wheat crops before senescence, grown on the same field in consecutive years. Input maps for the pyTSEB model were prepared using UAV-acquired multispectral/thermal imagery and ground control canopy leaf angle distribution (χ) and leaf area index (LAI) estimations based on canopy light transmission measurements by linear ceptometers. The modelled sensible and latent heat fluxes (HpyTSEB, LEpyTSEB) were validated against eddy covariance-measured respective fluxes (Heddy, LEeddy). Actual χ (χa) was estimated from 2 h courses of canopy light transmission values and ranged between 0.5 and 1.2 for wheat and between 2.8 and 5.8 for sunflower crops, respectively, affecting canopy light extinction coefficients (k) and LAI in both crops compared to the case of the generally assumed spherical leaf angle distribution (χ = 1). Vegetation cover fraction (fc) was 3.4% smaller in wheat when using χa instead of χ1, but this led to only minor—though significant—changes in modelled Tcan, Tsoil and canopy and surface resistances. The effect of leaf angle distribution on the combined validation of sensible and latent heat flux data was shown primarily in sunflower due to the decrease in sensible heat flux error, while validation improvement was not detectable in the case of wheat. Using field-calibrated thermal images instead of uncalibrated ones strongly improved validation results (fit of modelled vs. measured sensible and latent heat fluxes), showing the necessity of field calibration of the thermal camera when the data are used for vegetation energy balance modelling.
No takes yet. Share an insight, caveat, or question.
Pintér et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: