The ‘starting plume’ in neutral surroundings

The advancing front of a buoyant plume which is being established in uniform surroundings has some properties in common with the plume, while in other respects it behaves more like a ‘thermal’ released from rest. The solutions for these two cases cannot be matched directly, since the dependence of velocity on height is different. It is shown here that a similarity solution, which is consistent with the equations describing both parts of the flow, can be obtained once it is recognized that the velocity of the front may be less than that of the steady plume. The cap moves with a constant fraction of the plume velocity at the same level, and the total buoyancy in the cap is increasing, so a modification of the simple relations for thermals is required. This prediction is verified experimentally, and numerical values for the ratio of the velocities and the rate of increase of the cap radius with height determined. The extreme front of plume cap advances at about 0·6 times the mean velocity on the axis of a steady plume, and it spreads at just over half the angle of a thermal. This implies a smaller rate of entrainment and therefore a smaller rate of dilution per unit height compared with a thermal, especially since about half of the fluid mixed into the cap comes from the plume below. The model allows one to estimate the time necessary for convection from a known steady source on the ground to lead to the formation of a cloud.