Key points are not available for this paper at this time.
In the industrial use of stereolithography, precision is always a problem. The basic phenomenon of solidification shrinkage has not been sufficiently investigated. This study aims at clarifying the initial linear shrinkage of cured resin in a minute volume. Experimental equipment has been developed which measures the time history of the single strand in situ in a stereolithography machine. An analysis model of the time history of a minute volume linear shrinkage was shown using the measured shrinkage of a cured line segment. The relation between the time history of the linear shrinkage and temperature was measured and the shrinkage in the minute volume after irradiation was found to result due to temperature variation. Deformation and linear shrinkage were measured with two scanning orders to control the thermal distribution in layer forming. The effects of thermal distribution were also observed in one layer forming.
Narahara et al. (Wed,) studied this question.