Answers are grounded in this paper and cite their sources.
Correlation between changes in slope of secondary electron curve, and position of diffraction beams.---A narrow beam of electrons of variable speed is incident normally on the (100) face of a copper crystal. Measurements of the total secondary electron current are obtained under the same conditions as the angular distribution of scattered electrons for bombarding potentials from 0 to 250 volts, and after the crystal has been thoroughly degassed at red heat in an exceptionally good vacuum. The total secondary electron curve shows two maxima at 3 and 10.5 volts, respectively, and many sudden changes in slope in the region between 10.5 and 250 volts. Intense beams of full-speed electrons are found to issue from the crystal at such voltages as to account for the maxima, and for many of the changes in slope. Other beams are to be expected in the direction of the normal to the crystal, and hence are outside the solid angle of observation; they, however, contribute to the total secondary current, and appear sufficient to account for the remaining changes in slope. It thus appears that changes in the electron emission at potentials corresponding to energy levels within the atom are, at most, relatively unimportant in the production of sudden changes in slope in this region.Diffraction beams.---With two exceptions, all of the expected diffraction beams which are the x-ray analogues in the two principal azimuths, and in the range below 250 volts are found. In addition, 20 sets of beams are found, 12 of which satisfy the conditions required by a wave of one-half the length given by λ=h/mv, or by a double grating spacing. These beams appear not to be due to gas. A temperature effect is observed for both types of beams. One additional set of beams at 3 volts does not appear in either of the two principal azimuths, and is not accurately reproducible. Most of the beams are very intense and sharp. In the case of a 70-volt beam, the background scattering of full-speed electrons in azimuth under the best vacuum conditions is found to be only 4.3 percent of the maximum intensity of the beam.Refractive index.---Both types of classified beams require a refractive index greater than unity. The value of φ, however, in the expression μ=(1+φV)1/2 is not constant, but increases from 6 or 7 volts for beams at the lowest voltages to about 25 volts for the beams above 200 volts.Energy of scattered electrons.---After making correction for an error inherent in the method of measurement, it appears that the diffraction beams are composed entirely of full-speed electrons. These electrons in the case of the 70 volt beam comprise about 50 percent of all the electrons moving in the direction of the beam. Evidence of a selective angular distribution of emitted electrons, differing from that of the scattered electrons, is also obtained.
No takes yet. Share an insight, caveat, or question.
H. E. Farnsworth (1929) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: