A Hybrid Formwork System Integrating Steel Frame and 3D-Printed Modules for Complex Concrete Structures: Full-Scale Fabrication and Performance Evaluation

Conventional formwork systems are limited in their ability to efficiently realize complex and free-form concrete geometries, while additive manufacturing (AM)-based formwork faces constraints in casting-stage structural stability and cost-effectiveness, particularly at construction scale. To address these limitations, a hybrid formwork system integrating a structural steel frame with 3D-printed modules is proposed, in which the steel frame resists casting-induced lateral pressure while the printed components define complex mold geometries. The system was fabricated and validated through a full-scale case study structure measuring 3.0 m × 1.7 m × 2.2 m, produced using a large-scale fused deposition modeling (FDM) process with carbon-fiber-reinforced ABS (ABS-CF20). Geometric accuracy was evaluated by comparing design dimensions with as-built measurements across planar, edge, curved, and inclined regions. Construction efficiency and cost performance were assessed through process-based and cost-based comparisons with conventional steel formwork and fully 3D-printed formwork alternatives. The constructed structure reproduced the intended geometry with an average deviation of approximately 3.2 mm and a maximum deviation within ±4 mm, and no notable formwork deformation or damage was observed during concrete casting. Relative to conventional steel formwork, the hybrid system reduced total fabrication duration by about 50% and fabrication cost by about 60% based on a normalized cost index, while also outperforming fully 3D-printed formwork in cost efficiency by about 45%. The modular configuration and bolted connection system further improved transportability, on-site assembly efficiency, and component reusability. These findings demonstrate that the proposed hybrid formwork system provides a practical and resource-efficient pathway for fabricating complex concrete structures, supporting the broader adoption of digital fabrication in sustainable construction practice.