Key points are not available for this paper at this time.
Experimental and theoretical studies of the effect of an ultrasonically absorptive coating (UAC) on hypersonic boundary-layer stability are described. A thin coating of fibrous absorbent material (felt metal) was selected as a prototype of a practical UAC. Experiments were performed in the Mach 6 wind tunnel on a 7^ half-angle sharp cone whose longitudinal half-surface was solid and other half-surface was covered by a porous coating. Hot-wire measurements of ‘natural’ disturbances and artificially excited wave packets were conducted on both solid and porous surfaces. Stability analysis of the UAC effect on two- and three-dimensional disturbances showed that the porous coating strongly stabilizes the second mode and marginally destabilizes the first mode. These results are in qualitative agreement with the experimental data for natural disturbances. The theoretical predictions are in good quantitative agreement with the stability measurements for artificially excited wave packets associated with the second mode. Stability calculations for the cooled wall case showed the feasibility of achieving a dramatic increase of the laminar run using a thin porous coating of random microstructure.
Федоров et al. (Tue,) studied this question.