Key points are not available for this paper at this time.
In comparing observation based methane emission estimates for oil and gas well sites to routine emissions reported in inventories, the time scale of the measurement should match the time scale over which the inventoried emissions are estimated. Since many measurements are of relatively short duration (seconds to hours), a tool is needed to estimate emissions over these time scales rather than the annual totals reported in most emission inventories. This work presents a tool for estimating routine emissions from oil and gas well sites at multiple time scales; emissions at well sites vary over time due to changes in oil and gas production rates, operating practices and operational modes at the sites. Distributions of routine emissions (expected and inventoried) from well sites are generally skewed, and the nature and degree to which the distributions are skewed depends on the time scales over which emissions are aggregated. Abnormal emissions can create additional skew in these distributions. At very short time scales (emissions aggregated over 1 min) case study distributions presented in this work are both skewed and bimodal, with the modes depending on whether liquid storage tanks are flashing at the time of the measurement and whether abnormal emissions are occurring. At longer time scales (emissions aggregated over 1 day) distributions of routine emissions simulated in this work can have multiple modes if short duration, high emission rate events, such as liquid unloadings or large abnormal emissions, occur at the site. Multiple applications of the methane emission estimation tool (MEET), developed in this work, are presented. These results emphasize the importance of developing detailed emission inventories, which incorporate operational data, when comparing measurements to routine emissions. The model described in this work supports such comparisons and is freely available.
Allen et al. (Tue,) studied this question.