Answers are grounded in this paper and cite their sources.
This review evaluates buckling pressure equations for solid-wall polyethylene pipe, highlighting implications for design accuracy.
When an unconstrained polyethylene pipe is subjected to uniform external pressure (such as on the ocean floor or inside a slurry filled horizontal directionally drilled borehole), the pipe will slowly ovalize and elongate. This ovalization and elongation will continue as long as external pressure is applied or until the pipe buckles or until the pipe is pressurized above the external pressure. This paper presents a review of equations available to estimate unconstrained external pipe buckling pressure to show that the elastic buckling equation is most applicable for use with to solid wall polyethylene pipe. Historic research from three high density polyethylene (HDPE) pipe manufacturers performed to determine the unconstrained buckling pressure of their products is presented and used to validate the use of the elastic buckling equation (sometimes referred to as the Bryan, Love, or Timoshenko equation) on solid wall polyethylene (PE) pipe. This paper shows that buckling pressures calculated using the elastic unconstrained buckling equation with an iterated apparent tensile modulus match well with the buckling pressures extracted from historic research. Buckling pressures estimated for PE pipe using an elastic modulus based on a fixed stress value such as 400 psi can deviate widely from those calculated from iterated apparent modulus values based on hoop stress caused by the external buckling pressure. Improving the accuracy of unconfined buckling pressure estimates helps the design engineer make better decisions.
No takes yet. Share an insight, caveat, or question.
Christopher. W Ampfer (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: