Answers are grounded in this paper and cite their sources.
Evaluates antibacterial and mechanical effects of phosphorylated chitosan in dental resins, suggesting versatile applications.
The incorporation of antimicrobial agents into 3D-printed resins may improve their biological performance; however, their effects on physicochemical and mechanical properties remain unclear. This study evaluated the influence of phosphorylated chitosan (P-Chi; 0.25% and 0.50% w/w) incorporated into short- (ST) and long-term (LT) 3D-printed dental resins. Surface, mechanical, optical, and antibacterial properties against Streptococcus mutans were investigated using standardized methods. FTIR confirmed the successful phosphorylation and incorporation of P-Chi into both resin matrices. P-Chi significantly reduced S. mutans CFU counts compared with the control (p < 0.001, η2p = 0.286), regardless of concentration, although no inhibition halos were detected, indicating a contact-dependent antimicrobial mechanism. Enhanced antibacterial activity was accompanied by increased surface roughness and wettability. Nanoparticle concentration significantly affected mechanical performance (p = 0.001), whereas resin type did not (p = 0.613). The 0.25% groups exhibited lower flexural strength and microhardness than the controls (p < 0.05), while the 0.50% groups maintained flexural strength comparable to that of the controls, with G6 showing the highest elastic modulus (3494.95 ± 301.30 MPa). Color variation was influenced by resin type rather than P-Chi concentration (p < 0.05). Overall, P-Chi enhanced antibacterial activity while maintaining clinically acceptable mechanical properties, supporting its use as a multifunctional additive for biofunctional 3D-printed provisional resins.
No takes yet. Share an insight, caveat, or question.
Otavio et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: