Key points are not available for this paper at this time.
In this study, the mechanical behavior of novel fully grouted cable rock bolts made of basalt fiber–reinforced polymer (BFRP) was investigated, which included pullout and double-shear joint behavior. Three BFRP cables were prepared: (1) single-tendon; (2) untwisted multiple-tendon; and (3) twisted multiple-tendon. In the pullout tests, the effects of cable type, borehole diameter, and encapsulated length were studied. However, the influence of the pretension load level was focused on in the double-shear joint tests. The results suggested that an overly thick grout annulus significantly reduced the pullout strength and stiffness. For the BFRP cable with multiple tendons, the initial pullout stiffness was enhanced compared with the BFRP cable with a single tendon due to better interfacial bonding with the grout. In the double-shear joint tests, the pretension of the cable significantly improved the shear capacity and stiffness. With an enhancement in the confinement from pretension, the partial failure of the grout at an early stage could be prevented. The parallel and twisted-tendon BFRP cable rock bolts had larger failure displacements than the single-tendon cable. This analytical study found that a pullout analytical model available in the literature was accurate when back-calculating the stress conditions along the rock bolt. The predicted shear capacity of the rock joint showed good agreement with the experimental values. A parametric study indicated that the joint shear capacity was sensitive to the tensile and shear strengths of the cable but was irrelevant to the cable moduli. Considering the effectiveness of pretension and creep safety for BFRP, a suitable range for the pretension load was suggested.
Peng et al. (Mon,) studied this question.