Answers are grounded in this paper and cite their sources.
Examines wear resistance in high-entropy alloy coatings, suggesting improved protective ability.
The exceptional mechanical and thermal characteristics of high-entropy alloys (HEAs) have attracted substantial attention; however, their potential as protective coatings continues to be a major focus of ongoing research. This study examines the influence of zirconium (Zr) addition on the microstructural evolution, and the mechanical and tribological performance of flame-sprayed AlCoCr 2 FeMo 0.5 Ni-Zrₓ (x = 5, 10, and 15 wt%) coatings synthesized on SS 316 L substrates. Mechanical properties were evaluated via microhardness testing, while tribological behavior was assessed through multi-pass scratch wear experiments. Phase analysis revealed a dominant body-centred cubic (BCC) solid-solution phase, along with secondary phases such as ZrO₂, Cr₂O₃, and spinel oxide. The incorporating Zr significantly improved the coating hardness, with AlCoCr 2 FeMo 0.5 Ni-Zr 5 (585 HV 0.3 ), AlCoCr 2 FeMo 0.5 Ni-Zr 10 (720 HV 0.3 ), and AlCoCr 2 FeMo 0.5 Ni-Zr 15 (907 HV 0.3 ) exhibiting microhardness values ~3.7, 4.6, and 5.7 times higher than that of SS 316 L (158 HV 0.3 ), respectively, owing to the combined contributions of solid-solution strengthening and ZrO 2 -induced oxide dispersion hardening. Among the coatings, AlCoCr 2 FeMo 0.5 Ni-Zr 10 exhibited the lowest coefficient of friction (COF) of 0.11 the minimum specific wear rate of 4.48 × 10 −3 mm 3 /N·m, with reductions of 68.3% in COF and 72.5% in specific wear rate compared to uncoated SS 316 L. The superior performance was attributed to a well-balanced combination of hardness and toughness, reflected by high H / E and H 3 / E 2 ratios. These findings demonstrate that Zr-modified AlCoCr 2 FeMo 0.5 Ni HEA coatings deposited via flame spraying exhibit enhanced multi-pass scratch wear resistance, providing new insights into the design of wear-resistant HEA coatings for industrial applications involving severe sliding and abrasive environments.
No takes yet. Share an insight, caveat, or question.
Vyas et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: