Answers are grounded in this paper and cite their sources.
Evaluates thermal performance in high-power-density motors, indicating optimal cooling configurations.
The stator core water-cooling structure is an effective thermal solution for high-power-density permanent magnet synchronous motors (PMSMs). However, the additional thermal outlets of circulation loss and eddy loss introduced by the cooling pipes often were neglected. This paper presents a comprehensive thermal performance research by adopting three-dimensional lumped parameter thermal network (LPTN) model with considering the additional thermal generation of circulation loss and eddy loss. 2,486 structural configurations were evaluated by LPTN and results reveal that both the number and radial position of cooling pipes significantly influence temperature distribution due to the combined effect of heat generation caused by additional thermal generation of pipe losses and cooling effect. The fully parallel configuration of water-cooled tubes suppresses circulation losses by canceling out induced potential differences along the pipelines. This proposed configuration reduces pipe loss,which consists of eddy current loss and circulation loss, by 56.8% compared to conventional fully parallel designs. The average magnetic flux density on pipe walls increases approximately linearly near stator slots, while exhibiting exponential growth with increasing diameter; since eddy current losses are proportional to the square of magnetic flux density, these losses surge dramatically near slot regions in large-diameter pipes, reaching levels comparable to stator iron losses. Increasing the number of pipes makes both eddy current loss and stator iron loss increased, with the latter being more significantly affected. Although closing to slots shortens the thermal path between windings and heat sink, eddy current loss grows more markedly, ultimately exacerbating winding temperature rise. While larger pipe diameters reduce convective heat transfer resistance, they increase eddy current circulation area, thereby boosting pipeline loss; when pipes are positioned away from slots, the cooling enhancement from increased diameter proves less effective than the additional heat source effect, similarly leading to higher winding temperatures. By balancing these competing parameters, the optimal configuration was determined to have an outer diameter of 10.4 mm and a distance of 43.8 mm from the stator inner edge, achieving a minimum steady-state temperature rise of 44.9 K. Prototype experiments validated the accuracy of the model, with the maximum temperature prediction error below 3.8%. This work provides a robust methodology for the design and optimization of stator core cooling systems in high-power-density motors.
No takes yet. Share an insight, caveat, or question.
Du et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: