Answers are grounded in this paper and cite their sources.
Investigates plasticity limits to enhance infiltration in bioinfiltration and bioretention media, suggesting important design adjustments.
In bioinfiltration and bioretention systems for stormwater management, the saturated hydraulic conductivity (Ksat) of the media is a critical factor determining system performance. Media specifications are typically based on texture and often do not consider mineralogy or plasticity of the fine fraction. However, even in soil mixes with low clay contents (<10%), increases in plasticity index (PI) have been shown to correlate to substantial decreases in Ksat (e.g., by orders of magnitude). Thus, this study paired laboratory investigations with field studies to investigate the use of PI limits as a screening tool for proposed bioinfiltration and bioretention media. Measured Ksat values for a range of field sites and laboratory tests were compared with the media PI, texture, and particle size distribution. All the media met current relevant regulatory guidelines and were representative of common bioinfiltration/bioretention conditions (texture classifications of sand, loamy sand, sandy loam; organic content of 5–15%; density of 1.05–1.20 g/cm3). The results indicated that media with PI>13 typically exhibited insufficient infiltration, with Ksat<1.8×10−6 m/s (0.25 in./h), whereas media with PI<10 consistently achieved higher Ksat. For the data set, no apparent correlation was observed between the USDA textural classification and Ksat performance. However, based on USCS classification (which incorporates PI), media with insufficient Ksat consistently classified as clayey sand (SC). The results support future inclusion of PI limits in media specifications and material compliance screening for bioinfiltration and bioretention systems.
No takes yet. Share an insight, caveat, or question.
Marino et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: