Experimental and Numerical Investigation on Fe-SMA Strengthening of U-Rib Butt-Welded Joints with Porosity Defects

To investigate the influence of porosity defects and the strengthening effect of bonded iron-based shape memory alloy (Fe-SMA) plates, fatigue tests were conducted on defect-free, porosity-containing, and Fe-SMA-strengthened U-rib butt-welded specimens. A numerical model considering porosity defects and the bonded Fe-SMA plate was also established and validated against the experimental results. The results show that porosity defects significantly increased the local stress level near the crack. Under a load of 60 kN, the stress at the section 2 mm from the crack edge increased from 98 MPa to 139.5 MPa. Meanwhile, the fatigue life decreased from 260 × 104 cycles to 127 × 104 cycles. After Fe-SMA strengthening, the stress decreased to 75.59 MPa, and the fatigue life increased to 326 × 104 cycles, which was 2.57 times that of the unreinforced defective specimen. The Fe-SMA plate did not change the fatigue crack propagation path but effectively slowed crack growth through local stiffness enhancement and activation-induced pre-compressive stress. Parametric analysis further showed that, among the investigated numerical cases, an activation temperature of 200 °C produced the largest predicted strengthening effect. Increasing the pore diameter from 0.5 mm to 2.0 mm reduced the reinforcement effect from 69.45% to 52.98%, and increasing the crack length from 10 mm to 50 mm reduced it from 65.41% to 35.53%. These results indicate that bonded Fe-SMA plates can effectively improve the fatigue performance of U-rib butt-welded joints with porosity defects, especially when applied before excessive crack growth occurs.