Key points are not available for this paper at this time.
Based on self-developed ultra high frequency pulse Metal-Inert Gas Welding (UFP-MIG) power source, the ultra-high frequency pulse (UFP) current was studied as an effective way for improving the microstructure and properties of 2219 aluminum alloy joints. The welding pores reduction performance, microstructures, microhardness, and tensile properties of conventional pulsed MIG(CP-MIG) welds and the UFP-MIG welds with different modes and frequencies were investigated. The results indicated that the UFP-MIG process could almost completely eliminate welding porosity in the joints of 2219 aluminum alloy. Compared with CP-MIG welding process, the grain size of the UFP-MIG welding zone was reduced and gradually decreased as the frequency of UFP increased. Similarly, the grain refinement effect also appeared in the heat affected zone (HAZ) near the welds, and the grain size could be reduced by up to 14.85%. Meanwhile, the morphology and uniformity of θ phases and α+θ eutectics along grain boundaries of UFP-MIG welds were also improved. The microhardness in the weld zone and partially melted zone (PMZ) of UFP-MIG weld joints with different modes and frequencies were significantly improved. The highest joint average microhardness occurred at peak pulse mode (PP) with 40 kHz(75.17HV), which was 27.9% higher than that of CP-MIG (58.74HV). The strength and ductility of welded joints were simultaneously improved by UFP-MIG weld process. Fracture analysis results showed that the large reduction of weld pores, the refinement of weld grains, and the lower segregation of Cu element in the eutectic were responsible for the joint tensile properties improvement.
Kuang et al. (Wed,) studied this question.