Answers are grounded in this paper and cite their sources.
Experimental study investigates vibrational characteristics of mistuned compressor blades, indicating significant implications for compressor performance.
The vibrational characteristics of mistuned compressor blades were experimentally investigated using a blade tip timing (BTT) technique. Experiments were conducted on a single-stage axial compressor, focusing on two representative vibration mechanisms: rotating-stall-induced vibration near the stability limit and forced vibration excited by upstream aerodynamic disturbances. Under stall conditions, pronounced blade vibration was observed. Spectral analysis revealed a dominant low-frequency component in both blade-tip fluctuating pressure and blade vibration signals. As the rotational speed increased, the vibration amplitude grew monotonically, showing an approximately linear relationship between the average blade vibration amplitude and the normalized rotational speed. To investigate forced vibration behavior, a set of upstream spoilers was installed to introduce periodic aerodynamic excitation. Forced response tests were carried out at engine orders EO = 10 and EO = 12. The results show that mistuning leads to significant blade-to-blade variations in vibration amplitude. While the average vibration amplitude decreases with increasing engine order, the amplitude magnification factor increases, indicating enhanced response localization among mistuned blades. This study contributes to a better understanding of blade dynamic behavior under both rotating-stall–induced and forced vibration conditions and offers useful experimental insight for vibration assessment of compressor blades operating near stability limits.
No takes yet. Share an insight, caveat, or question.
Ting et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: