Answers are grounded in this paper and cite their sources.
Experimental study assessing mechanical properties and biocompatibility of CNF-reinforced Mg-Zn alloys, suggesting improved outcomes for temporary surgical implants.
Background Current material designs for orthopaedic implants are limited to non-degradable metals, such as titanium alloys, stainless steel, and cobalt-chromium. In case of temporary fixations, secondary surgeries are required for removal, which may further lead to patient discomfort and increases financial burden. Alternatively, magnesium (Mg) alloys are emerging as potential biodegradable metal as temporary implant material. However, its use is yet limited due to low mechanical stability and rapid degradation rate in the physiological environment. Carbon nanofiber (CNF) reinforcement provides potential to improve these characteristics. Purpose This study aims to investigate the effect of CNF reinforcement on the microstructural, mechanical, in vitro degradation, and biocompatibility properties of Mg-Zn alloys fabricated by powder metallurgy (PM). CNF at 0.1, 1.05, and 2.0 wt% were varied into Mg-4wt%Zn, compacted at 400 MPa and sintered at 500 °C. Results Increasing CNF content promoted grain coarsening and improved densification, with Mg-Zn/2.0 wt%CNF showing 1.85 ± 0.1 g/cm 3 density. Raman spectroscopy showed the presence of D, G, and G′ bands, indicating that CNF-related carbon features remained detectable after ball milling and sintering. XRD confirmed α-Mg as the primary phase with γ-MgZn, alongside CNF-induced variations in basal and prism plane intensities. Hardness increased with CNF content (57.9 ± 14 HV at 2.0 wt%CNF), whereas yield strength peaked at 227.39 ± 28.4 MPa for 0.1 wt% CNF. Strengthening was attributed to Orowan mechanisms and enhanced load transfer. Ion release analysis showed that Mg-Zn/2.0 wt% CNF reduced Mg 2+ release compared with unreinforced Mg-Zn after 7 days of immersion in PBS. All Mg-Zn/CNF composites showed cell viability above 70%, indicating non-cytotoxic behaviour. Conclusion Overall, CNF-reinforced Mg-Zn alloys exhibit promising characteristics for bioabsorbable orthopaedic implants. Higher CNF content improved densification, hardness, stiffness, and reduced Mg 2+ release, while lower CNF content provided higher yield strength and more favourable cytocompatibility. These findings suggest that CNF content should be optimized to achieve a balanced combination of mechanical stability, degradation response, and biological performance for potential orthopaedic implant applications.
No takes yet. Share an insight, caveat, or question.
Nazemi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: