Transition delay in a Mach 6 boundary layer using steady blowing and suction strips

Direct numerical simulations (DNS) were carried out to investigate flow control for transition delay using steady blowing/suction strips at the wall of a flared cone at Mach 6 and zero angle of attack. For the numerical investigations of the transition control strategy, the flared cone geometry and the flow conditions of the experiments in the Boeing/Air Force Office of Scientific Research (AFOSR) Mach 6 Quiet Tunnel (BAM6QT) at Purdue University were chosen. For the DNS, transition was initiated by introducing random disturbances at the inflow of the computational domain, emulating ‘natural’ transition in wind-tunnel experiments caused by free-stream noise. In both wind-tunnel experiments and numerical simulations, streamwise ‘hot’ streaks were found on the surface of the flared cone, which are caused by a nonlinear interaction of an axisymmetric second-mode wave and a pair of oblique waves of the same frequency (‘fundamental resonance’). The objective of the flow control strategy proposed here is to delay the transition onset, and thus mitigate the negative consequences associated with the nonlinear transition stages, i.e. the development of hot streaks and large wall-pressure amplitudes that were observed in experiments and DNS. Our previous so-called ‘controlled’ transition simulations have shown that flow control using steady blowing and suction strips can lead to a significant delay of the hot streak development on the surface of the flared cone. The simulation results presented in this paper show that this flow control strategy remains effective, even in a natural transition scenario characterized by broadband disturbances.