Answers are grounded in this paper and cite their sources.
The effect of forced cooling using heat sinks on the mechanical properties and interpass waiting time of two-pass welds has been studied for a martensitic steel with a yield strength of 960 MPa when the interpass temperature was 100 °C. Cross-weld tensile and − 40 °C Charpy-V impact toughness properties were examined. The use of heat sinks is shown to result in a beneficial increase of the cross-weld yield strength but at the expense of the yield-to-tensile strength ratio. Due to its particularly detrimental effect on the heat-affected zone (HAZ) toughness of multipass welds, special attention was given in the Charpy-V toughness of the intercritically reheated coarse-grained HAZ (ICCGHAZ) by also testing simulated ICCGHAZs. It is shown that forced cooling has a beneficial effect in respect of the toughness of this simulated subzone and on the Charpy-V toughness of the HAZ of the actual welds. The interpass cooling time during the two-pass welding was reduced by 37%. The results indicate that, in the case of high-strength steels, it may be possible to simultaneously improve both welding productivity and mechanical properties by using forced cooling down to 100 °C to reduce waiting time between weld passes.
No takes yet. Share an insight, caveat, or question.
Laitila et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: