Quartz-enhanced photoacoustic spectroscopy sensing using trapezoidal- and round-head quartz tuning forks

In this Letter, two novel, to the best of our knowledge, quartz tuning forks (QTFs) with trapezoidal-head and round-head were designed and adopted for quartz-enhanced photoacoustic spectroscopy (QEPAS) sensing. Based on finite element analysis, a theoretical simulation model was established to optimize the design of QTF. For performance comparison, a reported T-head QTF and a commercial QTF were also investigated. The designed QTFs have decreased resonant frequency ( f 0 ) and increased gap between the two prongs of QTF. The experimentally determined f 0 of the T-head QTF, trapezoidal-head QTF, and round-head QTF were 8690.69 Hz, 9471.67 Hz, and 9499.28 Hz, respectively. The corresponding quality ( Q ) factors were measured as 11,142, 11,411, and 11,874. Compared to the commercial QTF, the resonance frequencies of these QTFs have reduced by 73.45%, 71.07%, and 70.99% while maintaining a comparable Q factor to the commercially mature QTF. Methane (CH 4 ) was chosen as the analyte to verify the QTFs’ performance. Compared with the commercial QTF, the signal-to-noise ratio (SNR) of the CH 4 –QEPAS system based on the T-head QTF, trapezoidal-head QTF, and round-head QTF has been improved by 1.75 times, 2.96 times, and 3.26 times, respectively. The performance of the CH 4 –QEPAS sensor based on the QTF with the best performance of the round-head QTF was investigated in detail. The results indicated that the CH 4 –QEPAS sensor based on the round-head QTF exhibited an excellent linear concentration response. Furthermore, a minimum detection limit (MDL) of 0.87 ppm can be achieved when the system’s average time was 1200 s.