Key points are not available for this paper at this time.
Because of the high synthesis cost, strong chemical inertness, complex process, and easy to endanger environment of traditional carbon-based nanolubricant additives, the development of its application in lubrication is limited. Therefore, a new type of lubricant additive with low cost, high yield, high performance, and environmental protection is urgently needed. Herein, a kilogram-scale carbon dots (CDs) lubricant additive was prepared by a simple and green one-step reaction of aldol condensation, which showed excellent lubricating properties in water and sunflower oil. The tribological properties of the CDs lubricant additive at different concentrations, loads, and speeds were systematically studied. The results show that the average friction coefficient of water is significantly reduced by 75% by a CDs lubricant additive. In particular, CDs not only exhibited excellent service life and lubrication stability during friction but also kept the friction coefficient change rate of sunflower seed oil close to 0 within 500 min. According to the tribological evaluation and wear surface analysis, the lubrication mechanism of CDs was attributed to their own morphological characteristics and abundant oxygen-containing functional groups on the surface. In the friction process, the charge adsorption effect, the adsorption protective film, and the hydrogen bonding layer are generated, which play an essential role in obvious antiwear and friction reduction. Therefore, this work provides a reference for the preparation of high-performance and high-yield lubricant additives.
Zhang et al. (Fri,) studied this question.