Answers are grounded in this paper and cite their sources.
Finds enhanced mechanical properties in Zn-coated press-hardening steel, suggesting viable industrial application.
Direct hot press forming (DHPF) of Zn-coated press-hardening steel (PHS) has not been widely adopted by industry due to liquid metal embrittlement (LME), which occurs when coated steel is hot stamped above the Fe-Zn peritectic temperature (~782 °C). In the present study, low-temperature hot stamping was performed on a 2.0 wt% Mn PHS to avoid LME by preventing liquid zinc formation during plastic deformation while achieving target mechanical properties (yield strength (YS) ≥ 1100 MPa and ultimate tensile strength (UTS) ≥ 1500 MPa) and preserving corrosion performance. The enhanced hardenability, indicated by a critical cooling rate (CCR) of 10 °C/s, enabled a predominantly martensitic microstructure following DHPF at 550–700 °C. Tensile testing of samples extracted from U-shaped panels yielded similar results for uncoated and Zn-coated samples, with a YS of ~1170 MPa, a UTS of ~1600 MPa, a uniform elongation (UE) of 0.05, and a total elongation (TE) of 0.09, demonstrating the preservation of baseline mechanical properties in the coated samples. Microstructural analysis confirmed the absence of LME-induced substrate cracking. Additionally, XRD, SEM-BSE, and EDS analyses confirmed Γ-Fe3Zn10 formation in DHPF galvanized coatings, with volume fractions averaging ~0.6, well above the critical value of 0.15, irrespective of the DHPF temperature, demonstrating the formation of a cathodically protective coating microstructure.
No takes yet. Share an insight, caveat, or question.
Khalatbari et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: