Answers are grounded in this paper and cite their sources.
Investigates oxidation behaviour in Fe–Cr–Al alloy, suggesting processing routes significantly impact performance.
The influence of the consolidation route on the microstructure and high-temperature oxidation behaviour of the non-equiatomic Fe 1.5 Cr 1 Al 0.75 Mo 0.1 Ti 0.1 Ni 0.25 multi-principal element alloy (MPEA6) was systematically investigated. Samples were fabricated by casting, Spark Plasma Sintering (SPS), and Electric Resistance Sintering (ERS) in order to isolate processing-induced effects while preserving constant composition. Although all routes preserved the BCC–B2 phase constitution, significant differences were observed in grain size, precipitate morphology, and structural homogeneity. Spark Plasma Sintering allowed controlled grain refinement and tuning of B2 precipitate size through adjustment of sintering conditions, whereas ERS produced ultrafine B2 precipitates (30–40 nm) but introduced intrinsic porosity gradients. Hardness measurements revealed a competition between grain boundary strengthening and precipitation strengthening, reflecting the combined influence of grain size and B2 dispersion. Oxidation tests at 800°C for 48 h showed that the SPS-processed condition with refined and homogeneous microstructure developed thinner and more uniform oxide scales compared to the cast alloy. These results demonstrate that oxidation resistance in MPEA6 is governed not only by nominal composition but also by the processing-controlled microstructural state. Processing, therefore, emerges as a key design parameter to tailor both mechanical and environmental performance in Al-containing MPEAs.
No takes yet. Share an insight, caveat, or question.
Carbajales et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: