Answers are grounded in this paper and cite their sources.
Aluminum alloys have high corrosion resistance and weldability and are widely used in various manufacturing industries (aviation, automotive, shipbuilding). In this work, ER5356 welding wire with a diameter of 1.2 mm is used as a material for surfacing, and Al-5Mg alloys are manufactured by the method of wire-arc additive manufacturing based on cold metal transfer (WAAM-CMT) using three different welding arc modes (CMT, CMT-ADV, CMT-P). The study of the phase composition, microstructure and microhardness of Al-5Mg alloy samples was carried out. The results show that when using different arc modes, the diffraction patterns of α-Al differ significantly, and the main components of Al-5Mgalloys are α-Al and β-Al3Mg2. Two regions of microstructure are observed: the interlayer region (MSO) and the region of the inner layer (OAT), small columnar grains with pores and cracks are formed in the MSO, and large equiaxed grains are formed in the OAT. For all arc modes, the microhardness of the upper and lower regions of the sample is slightly greater than the average region. The microhardness of the sample produced according to the SMT-ADV mode (compared with the SMT and SMT-P modes) has the highest average value. This is mainly due to the fact that with a lower heat input, grains with the smallest size are formed (31.4–89.4 microns inMSO, 59.9–106.9 microns in OATS).
No takes yet. Share an insight, caveat, or question.
Su et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: