Key points are not available for this paper at this time.
• CFD and Simulink used to assess gear pump behavior under variable conditions. • Flow rate dropped at higher temperatures despite increased velocity and pressure. • Pressure gain and RPM linked to internal flow instability and overload risk. • Results highlight failure-prone thresholds for safer hydraulic system design. This study presents a computational investigation into the failure-relevant performance characteristics of hydraulic gear pumps by analyzing the influence of key operational parameters: fluid temperature, rotational speed, and pressure gain. A 12 cm³/rev dual spur gear pump model was developed in SolidWorks and simulated using ANSYS Fluent with transient, incompressible, and turbulent flow assumptions. Boundary conditions were dynamically controlled via Simulink, enabling precise variation of fluid temperature (30 °C–90 °C), rotational speed (1000–3000 RPM), and pressure gain (200–240 bar). The results revealed that both flow velocity and pressure increase significantly with rising temperature and rotational speed, indicating enhanced fluid momentum and higher mechanical stress within the chambers. However, at elevated temperatures, the decrease in viscosity led to reduced mass flow rate, implying potential flow instability and performance degradation. The findings suggest that excessive thermal and dynamic loads can trigger cavitation or internal leakage that marks critical operational thresholds for gear pump reliability. The study emphasizes that integrating CFD and control-based simulation provides a predictive framework to identify failure risks and optimize hydraulic system design.
Jasim et al. (Wed,) studied this question.