Answers are grounded in this paper and cite their sources.
Oxy-fuel combustion is a promising route for decarbonising combined heat and power (CHP) plants because it enables inherently high CO₂ capture rates without the thermal penalty typical of post-combustion systems. However, its application to medium-scale district-heating CHP plants remains largely unexplored. This work investigates two direct-fired oxy-fuel CHP concepts for a 20 MW LHV natural-gas-fired plant, where the flue gas is directly used as the working fluid. The first is an H 2 O-based cycle - evaluated in gas turbine and steam turbine configurations - in which water recirculation produces an H 2 O-rich working fluid that maximises latent-heat recovery. The second is a novel CO 2 -based OxyCascade cycle, in which CO 2 is recirculated, expanded in a turbine, and then exploited through a bottoming organic Rankine cycle and a tail-end condenser, favouring higher electrical output. The results reveal a clear trade-off between electrical and thermal performance governed by the choice of moderating fluid. The H 2 O-based layouts achieve global CHP efficiency up to 95–96%, thanks to extensive latent heat recovery, but modest net electrical efficiencies of 11–12%. By contrast, the OxyCascade cycle reaches 21.8–23.6% net electrical efficiency with 85–90% global CHP efficiency. CO 2 capture rates exceed 92% in all cases. Benchmarking against a CHP gas turbine with post-combustion CO 2 capture reveals a solvent regeneration penalty exceeding 20 percentage points in global CHP efficiency - a limitation entirely avoided by the oxycombustion approach. These results establish oxycombustion as a credible pathway for near-zero-emission district heating, with the moderating fluid governing the electricity-to-heat trade-off.
No takes yet. Share an insight, caveat, or question.
Doninelli et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: