Answers are grounded in this paper and cite their sources.
Advanced high strength steels and aluminium alloys have gained increasing popularity because of the constant effort to meet the goal of reducing vehicle weight while keeping its safety. The ratio between material strength and weight is much higher when compared to other materials. On the other hand, one of the disadvantages of these materials is the high springback after forming, particularly for parts exhibiting twisting and side wall curl, which are the two most difficult types of springback to control and compensate in die engineering. This study analyses the influence of several material and process parameters on the prediction of the twist springback, in a part that considers a stake bead, thereby changing the forming conditions from draw to stretch forming, at the end of the process. The modelling of the elastoplastic behaviour of the sheet materials (DP980 steel and a 6xxx aluminium alloy) uses a wide range of experimental data. For each material, the effect of the following parameters is analysed numerically: (i) friction coefficient; (ii) modulus of elasticity; (iii) yield criterion; (iv) work hardening law; and (v) process conditions, including initial thickness. The predicted twist springback is mainly affected by the friction coefficient and the elastic modulus. On the other hand, the yield criterion has little influence on the springback for this particular component and loading scenario, for both materials. Globally, steel and aluminium alloy exhibit different trends in the predicted twist springback: the former shows a counterclockwise rotation, whereas the latter displays a clockwise rotation. The results indicate that this different behaviour is strongly governed by the material hardening rate.
No takes yet. Share an insight, caveat, or question.
Oliveira et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: