Key points are not available for this paper at this time.
In this study, the fuel properties of mosses and algae, and the effect of pyrolysis temperature on the yield of bio-oil from moss and alga samples, were investigated. The yield of bio-oil from pyrolysis of the samples increased with temperature. The yields were increased up to 750 K in order to reach the plateau values at 775 K. The maximum yields were 39.1, 34.3, 33.6, 37.0, 35.4, 48.2 and 55.3% of the sample for Polytrichum commune, Dicranum scoparium, Thuidium tamarascinum, Sphagnum palustre, Drepanocladus revolvens, Cladophora fracta and Chlorella protothecoides, respectively. The bio-oil yield for Chlorella protothecoides (a microalga sample) rose from 5.7 to 55.3% as the temperature rose from 525 to 775 K, and then gradually decreased to 51.8% and was obtained at 875 K with a heating rate of 10 K/s. Formulas can be developed to calculate higher heating value (HHV) of different moss and alga samples. The calculated HHV using these new correlations showed mean differences ranging from −2.3% to +0.06%. The equation developed in this study showed good agreement with experimental results on moss and algae samples. The HHVs for bio-oils from mosses 21.5–24.8 MJ/kg and the HHVs for bio-oils from algae and microalga 32.5 and 39.7 MJ/kg, respectively, were obtained at temperature ranging from 775 to 825 K. In general, algae bio-oils are of higher quality than bio-oils from mosses. In general, microalgae bio-oils are higher quality than bio-oil from wood.
Ayhan Demirbaş (Thu,) studied this question.