Answers are grounded in this paper and cite their sources.
The performance of cementitious materials is strongly influenced by the effectiveness of chemical admixtures during hydration. Among these, naphthalene-based superplasticizers are widely used to improve workability without increasing water content. While considerable research has focused on optimizing admixture dosage, the influence of the timing of superplasticizer addition has received comparatively less attention. This study investigates the effect of delayed addition of a naphthalene-based superplasticizer on the workability and early-age compressive strength of cement mortar. Mortar mixes were prepared using OPC 43 grade cement, M-sand, water, and a naphthalene-based superplasticizer, which was introduced at delay periods of 0, 2, 4, 6, 8, 10, and 12 min after the commencement of mixing. Workability was evaluated using flow table tests, while 5-day compressive strength was determined for selected mixtures. The results showed that flowability increased from 120 mm for immediate addition to a maximum of 145 mm at an addition time of 8 min, followed by a decline to 105 mm at 12 min. Similarly, the 5-day compressive strength increased from 20.0 MPa for immediate addition to 24.2 MPa at a 10 min delay, representing an improvement of approximately 21%. The observed behaviour is attributed to enhanced cement particle dispersion and improved hydration efficiency resulting from delayed admixture addition. The findings demonstrate that the timing of superplasticizer incorporation is an important parameter influencing both the fresh and hardened properties of cement mortar and should be considered alongside admixture dosage in mix design and production practices.
No takes yet. Share an insight, caveat, or question.
Khan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: