Answers are grounded in this paper and cite their sources.
In vitro study evaluates the effects of beverages on resin composites' properties, indicating material differences in stability.
Frequent consumption of acidic and chromogenic beverages is common among children and may affect the longevity of direct restorations. Resin-based composites with differing resin matrix microstructures may exhibit distinct levels of resistance to discoloration and surface changes. However, scientific data regarding this issue is lacking. The purpose of this in vitro study was to evaluate the influence of commonly consumed beverages on the surface roughness average (Ra) and color properties (color difference [ΔE 00 ] and relative translucency parameter [RTP 00 ]) of resin-based composites. A total of 96 specimens (10 mm in diameter × 2 mm in thickness) were fabricated from 3 resin-based composites: An ormocer -based composite (Admira Fusion 5), a nanohybrid composite (Grandio SO), and a microhybrid composite (Filtek Z250). Measurements were obtained at three sequential phases: (1) baseline, (2) after thermocycling, and (3) after immersion in commonly consumed beverages. At baseline, the color coordinates of the specimens were recorded using a spectrophotometer, and Ra values were measured using a contact profilometer (Phase I). Following 5,000 thermocycles, color coordinates and Ra values were measured again (Phase II). Subsequently, all specimens were immersed for 6 days in commonly consumed beverages—distilled water (control), cola, cocoa milk, and iced tea—and the same measurements were repeated (Phase III). Color coordinates measured at each phase were used not only to determine ΔE 00 between the experimental phases but also to compute RTP 00 values at each phase. Data were statistically analyzed (α = 0.05). Thermocycling significantly affected RTP 00 and ΔE 00 values of the tested composites, although its effect on surface roughness was not significant. Dental composite material significantly affected Ra, RTP 00 , and thermocycling-related ΔE 00 values. During beverage immersion, solution type significantly affected ΔE 00 values, with a significant material × solution interaction indicating material-dependent staining behavior. Grandio SO exhibited the highest discoloration after cola and iced tea immersion, whereas Admira Fusion 5 demonstrated greater color stability across beverages. Resin-based composites responded differently to thermocycling and beverage exposure according to their resin matrix composition. The ormocer -based composite showed better color stability, although the nanohybrid composite was more susceptible to translucency changes and beverage-induced discoloration.
No takes yet. Share an insight, caveat, or question.
Şahin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: