Answers are grounded in this paper and cite their sources.
Shows enhanced response and recovery rates in SnO2 sensors using high-entropy alloying, indicating improved H2 detection capabilities.
As an effective sensitizer for chemiresistive hydrogen (H 2 ) sensors, the practical application of Palladium (Pd) is limited by the Sabatier principle, where intrinsically strong Pd─H binding leads to sluggish desorption kinetics and prolonged response and recovery time. A high‐entropy alloying strategy was proposed to tailor the local coordination and electronic structure of Pd active sites and weaken the Pd─H binding. Pd x (FeCoNiCu) 1− x ( x = 0.05–0.35)high‐entropy alloys (HEAs) were synthesized as sensitizers for SnO 2 to improve its H 2 sensing reactivity, especially its response and recovery rate. Pd 0.2 (FeCoNiCu) 0.8 ‐SnO 2 sensor exhibits short response and recovery time (0.6 s/2.0 s), a high response of 18.8 toward 100 ppm H 2 (4.06 times higher than Pd‐SnO 2 ), a practical detection limit of 1 ppm and a long‐term stability (>90% retention over 50 days). The working window of the sensor is also wider, which exhibits a linear response in both low (20–120 ppm) and high (4000–20 000 ppm) H 2 concentration ranges. Experimental analysis and theoretical calculation attribute this performance to the downshift of the Pd d ‐band center (from −1.84 to −2.57 eV). The electronic modulation alleviates the strong binding of hydrogen intermediates, thus leading to ultrafast response and recovery without compromising sensitivity.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: