Answers are grounded in this paper and cite their sources.
In order to investigate the influence of different shot peenings on the rolling contact fatigue life of case−hardened steel, the thrust type rolling contact fatigue test was performed with a ball−on−disk contact tester. In this study, the case−hardened steel disks were treated by the shot peening with a shot diameter of less than 0.1 mm. The surface hardness and the surface compressive residual stress of all the test disks were increased by the shot peening, and the surface roughness of most test disks was decreased by the shot peening. As the result of the rolling contact fatigue test, the rolling contact fatigue life of all the test disks was improved by the shot peening. The rolling contact fatigue life of the test disks became longer as their surface roughness became smaller. Therefore, it follows from this that the shot peening with a shot diameter of less than 0.1 mm, which can provide the decrease in surface roughness as well as the increase in both surface hardness and surface compressive residual stress, is suitable for the improvement in the rolling contact fatigue life of case−hardened steel.
No takes yet. Share an insight, caveat, or question.
SEKI et al. (2016) studied this question.
Synapse has enriched 8 related papers. Consider them for comparative context: