Answers are grounded in this paper and cite their sources.
Evaluates out-of-plane stability in chevron buckling-restrained bracing systems, highlighting implications for seismic design.
Buckling‐restrained braces (BRBs) are effective seismic energy dissipation devices, but their performance can be compromised by out‐of‐plane (OOP) buckling in connection zones, particularly under bidirectional seismic loading. The OOP instability mechanism in bidirectionally‐loaded BRBs, especially in chevron configurations with flexible central gusset plate (GP), remains poorly understood. This study comprehensively evaluates commonly used OOP stability assessment methods by designing and testing five chevron BRB‐GP systems under cyclic loading, focusing on the influence of loading conditions (unidirectional/bidirectional) and central GP stiffener arrangements (single/dual center stiffeners, varied fin stiffener lengths). Bolted end plate connections were employed to fasten the BRB ends to the GPs, both to simulate the typical welded BRB‐to‐GP connections as per Chinese practice, and to facilitate easy replacement of the BRBs during testing. Test results show that most BRBs failed prematurely due to a three‐hinge OOP instability mechanism, despite satisfying the current stability criteria for a number of methods that were considered in this study. Bidirectional loading significantly reduced seismic performance, with average decreases of 36% in compressive ductility and 83% in energy dissipation capacity. The performance could be significantly improved by the implementation of dual center stiffeners, which effectively limit OOP twisting of the central GPs, and the use of extended fin stiffeners, which enhance GP's OOP rotational rigidity and flexural strength. OOP drift introduced additional imperfections into the BRB‐GP systems, which, combined with initial imperfections, promoted earlier buckling. The combined influence of initial imperfections, OOP drift, and connection zone flexibility induced OOP moments on the central GP, triggering plastic hinge formation in the central GPs upon buckling. The presence of axial force reduced the OOP flexural strength of the central GPs, which is substantially overestimated by current theoretical models that assume flexural capacity provided by the stiffeners, rather than by the GP alone. The current OOP stability assessment methods significantly overestimate the experimental buckling strengths when the GP theoretical structural parameters are employed for evaluation. Key limitations of these methods and implications for BRB OOP stability design are presented to guide future improvements in design methodologies, as well as to offer broader insights for the next‐generation seismic design of BRBs and their connections under bidirectional loading.
No takes yet. Share an insight, caveat, or question.
Qin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: