Answers are grounded in this paper and cite their sources.
With advances in iron ore beneficiation, large quantities of ultrafine iron ore tailings (UFIOT) are generated annually, posing serious environmental and land-use challenges. However, the inherent inertness of UFIOT limits its direct utilization. In this study, ternary geopolymer composites were developed using UFIOT, fly ash (FA), and ground granulated blast furnace slag (GGBFS). The effects of the FA: GGBFS ratio on the physico-mechanical properties and microstructure of tailings-based geopolymers were systematically investigated. Results showed that increasing the FA: GGBFS ratio improved the fluidity but significantly reduced density, mechanical strengths, and ultrasonic wave velocity of geopolymers. The optimal performance was achieved at FA: GGBFS = 1:4 (F1G4), with uniaxial compressive strength (UCS), Brazilian splitting strength (BSS), and three-point bending strength (TPBS) of 35.87 MPa, 2.71 MPa, and 2.55 MPa, respectively. The high reactivity of GGBFS, rich in CaO, Al 2 O 3 , and SiO 2 , promoted hydration and geopolymerization, generating abundant C-(A)-S-H gels that bonded particles, filled pores, and densified the matrix. Strong correlations were established among mechanical strengths and ultrasonic wave velocity, with prediction errors below 5 % and R 2 ≥0.90. Microstructural analyses (XRD, FTIR, TGA-DTG, SEM-EDS) confirmed that F1G4 exhibited the higher degree of geopolymerization and the densest microstructure. EDS mapping further suggested that Fe in UFIOT remained inert, while Mg may contribute to (Ca, Mg)-Al-Si-H formation only in F4G1 specimens. The F1G4 specimens may be suitable for structural elements, while lower-strength variants serve non-structural applications such as masonry blocks, paving units, backfill, and mine-site construction products. Finally, the developed UFIOT–FA–GGBFS system valorizes mine tailings at scale and curbs Portland cement reliance, delivering direct sustainability gains through waste reduction, enhanced resource efficiency, and lower carbon emissions.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: