Answers are grounded in this paper and cite their sources.
Low carbon steel is widely used in many industrial products including steel framing, semi-finished (flat, square, or round) bars, machinery parts, etc., due to its low cost and good ductility [1]. However, as expected, its mechanical properties, especially the yield and tensile strength, are relatively low when compared to high-strength steels. Improving mechanical properties of these steels while retaining sufficient ductility to maintain good formability is an important research topic over the past decade with studies mainly focusing on innovative mechanical processing techniques that involve severe plastic deformation. A relatively new thermal processing technique known as “flash processing” was developed to produce resilient steel plates/sheet with improved strength while retaining some ductility using commercial low carbon steel [2]. By incorporating rapid heating and rapid cooling, the flash process generates heterogeneous microstructures throughout the coil’s thickness, resulting in hardness variations. In this study, a commercial AISI 1020 low carbon steel (Fe-0.21C-1.03Mn-0.3Si-0.06Al-0.04Cr-0.03Cu 0.01N-0.01Mo-0.01Ni-0.014P-0.002S wt.%) coil was used with an initial thickness ~1.14 mm. The flash process was performed using a custom-built machine. The machine was equipped with top rollers to guide the sheets into the induction coil, wherein the sheets were rapidly heated. After passing through the induction coil, the sheets continued into a quenching bath. Flash temperature was selected at 1125ºC.
No takes yet. Share an insight, caveat, or question.
Guo et al. (2021) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: