Answers are grounded in this paper and cite their sources.
Different approaches for the integration of mm-wave components have been presented recently, suggesting image line or shielded microstrip line for example. A very promising attempt employs quasi-planar structures, like fin-line, and related line configurations for this purpose. The paper gives a survey of various components being developed in the frequency range from 18 to 170 GHz using this approach.Broadband p-i-n-attenuators achieve an insertion loss below 1 dB and an isolation better than 25 dB covering either one or two entire waveguide bands. Narrowband resonator-type attenuators need only one diode to achieve similar results. At 94 GHz the attenuation of such a device can be adjusted between 1.5 and 35 dB. Fin-line detectors have been built between 18 and 170 GHz, with minimum sensitivity ranges from 400 to 100 mV/mW, depending on frequency. The conversion loss of a planar balanced mixer developed for Ka-band (26.5–40 GHz) amounts to 5 dB in a narrowband version and to 6–8 dB in a broadband, octave-wide version (18–40 GHz). For 60 GHz, a conversion loss down to 6.5 dB has been achieved. The unique advantage of the fin-line technique is demonstrated by a completely integrated Ka-band receiver front end, containing p-i-n-s.t.c, mixer and local oscillator. Fin-line couplers necessary for other integrated circuits have shown coupling factors up to crossover operation with full waveguide bandwidth.
No takes yet. Share an insight, caveat, or question.
Adelseck et al. (1982) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: