Answers are grounded in this paper and cite their sources.
(PIN-PMN-PT) relaxor ferroelectric single crystals and PZT-4 piezoelectric ceramics. The impedance spectrum of 31 modes was measured under constant voltage by the high-power piezoelectric system. From measuring the resonance and antiresonance frequencies, the high-field behaviors of the electromechanical coupling coefficients, elastic compliances, and piezoelectric coefficients of the PIN-PMN-PT crystals were determined and compared with commercial PZT ceramics. By fitting the equivalent circuit parameters under large electric fields, the mechanical quality factors of the PIN-PMN-PT single crystals and PZT-4 ceramics were calculated as well. The results showed that the mechanical quality factor of the PZT-4 is higher than that of PIN-PMN-PT, and the mechanical quality factors of the PZT-4 and PIN-PMN-PT both decrease sharply first and then decrease slowly with increasing the electric field. The tensile strengths of PIN-PMN-PT crystals and PZT-4 ceramics were also determined by the impedance method, where we found that the tensile strengths of PIN-PMN-PT crystal and PZT-4 ceramic were 19.6 and 76.4 MPa, respectively. The 31-mode vibrators of PIN-PMN-PT crystals and PZT-4 ceramics can be driven by the largest electric field of 33 and 65 V/mm under resonance frequency, respectively.
No takes yet. Share an insight, caveat, or question.
Li et al. (2020) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: