Answers are grounded in this paper and cite their sources.
Aim of study: The purpose of this study is to investigate the effect of the pilot-hole, screw type, screwing direction, water retention and adhesive on the screw pull resistance of the plywood. Material and Methods : Two types of screws, 3.5 mm and 4 mm in diameter, were used in the study. The supplied 18 mm thick plywood is sized to 50 mm x 50 mm according to TS EN 13446 standards. The pilot-holes were drilled so that 80% of the screw diameter would be used. After the polyvinyl acetate (PVAc) and polyurethane (PU) adhesives were injected into the pilot-holes, screwing was carried out perpendicularly and horizontally to the surface of the sample. Half of the samples were immersed in water for 2 hours before the screw withdrawal test. The results of the tests were interpreted by statistical analysis. Main results: When examining the results, all of the pilot-hole drilled samples showed higher screw withdrawal resistance than the pilot-hole drilled samples. It was also found that the screw withdrawal resistance perpendicular to the surface is higher than that parallel to the surface. When the glue applied pilot-hole specimens were examined, the PU specimens showed higher screw withdrawal strength than the PVAc specimens. A lower screw withdrawal strength was determined when samples were immersed in water. It was also found that as the screw diameter increases, the screw withdrawal strength increases. Research highlights: In is concluded that applying PU in pilot-holes before driving screw in significantly affected screw holding performance in plywood.
No takes yet. Share an insight, caveat, or question.
Yörür et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: