Answers are grounded in this paper and cite their sources.
Implementing nanofluid in heat transfer enhancement application is a modern and accessible method. In this present investigation Al2O3-water and CuO –water nanofluid with 1 % - 5 % volume fraction was chosen to study forced convective heat transfer enhancement through a semicircular corrugated pipe. 5000 W/m constant heat flux was considered as subjected to the pipe wall. The improvement was observed in both heat transfer rate and required pumping power with increased volume fraction of nanofluid comparing with base fluid water. The numerical simulation was analyzed in the range of Reynolds number 10,000 to 20,000. Effect of using nanofluid on total wall shear stress was also studied. 2% Al2O3-water and 1% CuO-water nanofluid were selected as they exhibit superior performances in enhanced heat transfer with optimum pumping power than water. Finally, the power advantage for both nanofluid was performed under prescribed flow condition.
No takes yet. Share an insight, caveat, or question.
Salehin et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: