Answers are grounded in this paper and cite their sources.
Fe-doped semi-insulating InP epitaxial layers were grown by low-pressure organometallic vapor phase epitaxy with tertiarybutylphosphine (TBP), triethylindium (TEI) and iron pentacarbonyl [Fe(CO)5] as the reactant gases. The growth was performed by varying the growth rate, growth pressure and V/III ratio. The epitaxial layers were characterized by optical microscopy, secondary ion mass spectrometry, double crystal x-ray diffraction and current-voltage measurements. Semi-insulating InP epitaxial layers with specular surface morphology and low defect density were obtained at TBP partial pressure higher than 0.38 torr. A premature reaction between TEI and TBP was observed which presumably formed TEI:TBP adducts and/or polymers. As a result, the growth rate of Fe-doped semi-insulating InP layers grown at low pressure with TBP in our reactor decreased by 35% as the V/III ratio was increased from 15 to 46. Electrical measurements on these layers showed that the resistivity varied from 1.7×107 to 4×108 Ω cm as the V/III ratio was increased from 15 to 46. The resistivity of TBP-grown materials is comparable to that of PH3-grown materials over a measurement temperature range of 25–110 °C. Selective growth and surface planarization of Fe-doped InP grown with TBP and trimethylindium on patterned etched mesas were achieved.
No takes yet. Share an insight, caveat, or question.
Huang et al. (1991) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: