Answers are grounded in this paper and cite their sources.
Polytetrafluoroethylene (PTFE) composites are essential materials for use in applications that cannot use liquid lubrication due to environmental constraints. These materials exhibit up to 10,000x improved wear performance when they develop and maintain tribofilms. Past work showed PTFE-Cr vs Brass 260 was able to maintain tribofilms and minimize wear, with wear rates ∼10x lower than the widely studied PTFE-α Al 2 O 3 vs 304 stainless steel. Meanwhile, PTFE-Cr showed ∼100x higher wear when slid against stainless steel. To determine how the chemical composition and mechanical properties of the counterbody influence the stark difference in tribological performance of PTFE-Cr, PTFE-Cr was evaluated against 304 SS, Brass 260, Cu 110, Pure Zn, Zn-Steel and Al 6061. Tribofilm develoment was monitored using ex-situ measurements of tribofilm height, tribofilm spacing and coverage, photography, surface energy, and chemical composition (infrared spectroscopy). PTFE-Cr wear was very dependent on the counterbody, with wear rates of K∼7.1×10 -9 mm 3 /Nm (Brass 260) to K∼8.3×10 -7 mm 3 /Nm (304 SS). Profilometry showed that only Brass 260 maintained tribofilm coverage and low surface roughness over the entire experiment. Worn Cu 110, Brass 260, Zn-coated Steel and Pure Zn counterbodies had lower surface energy than the worn surface of 304 SS, agreeing with optical observations of tribofilm coverage. Based on these observations, both abrasive and adhesive wear affect wear of PTFE-Cr due to surface roughness and tribofilm coverage respectively. Brass 260 minimizes wear via a transfer film with low surface roughness and maintaining a low surface energy gradient, diminishing both abrasion and adhesion.
No takes yet. Share an insight, caveat, or question.
Haque et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: