Answers are grounded in this paper and cite their sources.
The effect of applied tensile stress on the corrosion of commercial‐purity aluminium—magnesium alloys has been determined by subjecting the alloys, in the form of 16‐gauge wire, to intermittent immersion in 3% sodium chloride solution buffered at pH 6. Overstraining 10%, followed by ageing at 125° for 24 hours, renders aluminium‐7%‐magnesium alloy susceptible to stress‐corrosion with applied stresses as low as 2% of the U.T.S. (ultimate tensile strength), and aluminium‐5%‐magnesium alloy with stresses greater than 24% of the U.T.S. Stresses smaller than the threshold stress have little effect on the rate of attack. Under comparable stresses (per cent. of U.T.S.), the time‐to‐failure of the 5%‐magnesium alloy is considerably greater than that of the 7%‐magnesium alloy. A high proportion of the loss of strength due to stress‐corrosion occurs just before failure. Additional evidence is provided for the existence of points specially susceptible to stress‐corrosion which are distributed over the surface of the specimen.
No takes yet. Share an insight, caveat, or question.
Eric Jones (1954) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: