Answers are grounded in this paper and cite their sources.
The most cost-efficient method for utilization of the oil shale refinery by-products, viz., the retort gas and the shale gasoline, for power generation is combustion of these products in power-generating oil shale-fired boilers. Calculation studies carried out at the Estonian electric power plant in Narva, an enterprise of EESTI ENERGIA, have shown that recycling of the flue gases in the furnace of a TP-101 boiler enables an increase in the portion of the oil shale refinery by-products burned in the boiler from the current 7% to 40%. Recycling of the flue gases is aimed at maintaining the temperatures in the furnace at a level characteristic of combustion of oil shale and reducing the nitric oxide concentration in the retort gas burners’ flame. The degree of the flue gas recycling depends on the percentage of the burnt oil shale refinery by-products in the total heat generation and increases with the increasing percentage. For the threshold value of 40% under the rated conditions, the flue gas recycling accounts for 10%. A complete changeover of the boiler to combustion of only the retort gas in place of the oil shale does not seem to be possible, since this will necessitate major modification to the TP-101 boiler heating surfaces. Considering the obtained results, as a pilot project, one boiler furnace was modified by installing six retort gas burners and a flue gas recycling system.
No takes yet. Share an insight, caveat, or question.
Сидоркин et al. (2015) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: