This is the authors' abstract. We don't add key points for this paper.
The residual thermoelastic stresses were studied in Al 2 O 3 –ZrO 2 (monoclinic zirconia, m ‐ZrO 2 ) and Al 2 O 3 –ZrO 2 (Y 2 O 3 ) (tetragonal zirconia, t ‐ZrO 2 ) fibrous eutectics that were produced via the laser floating zone method, using different piezospectrosocopic probes. The luminescence of the R ‐lines of ruby (Cr 3+ in Al 2 O 3 phase) was used to determine the stresses in the Al 2 O 3 matrix, assuming that the stress state in the fibers was transversally isotropic. The sapphire matrix was subjected to tensile stresses in the Al 2 O 3 – m ‐ZrO 2 eutectics. The hydrostatic stress component attained a value of 1.13 GPa in well‐ordered regions. In contrast, sapphire was in compression in the Al 2 O 3 –ZrO 2 (Y 2 O 3 ) fibers, and the hydrostatic stress was −0.37 GPa in both ordered and disordered regions. The influence of the microstructure in the residual stresses was explained through thermoelastic analyses, based on a self‐consistent method. In addition, the Raman spectra of m ‐ZrO 2 and the 417 cm −1 Raman mode of Al 2 O 3 were measured in samples that showed different microstructures and thermoelastic stresses. An approximate linear dependence was observed in the tension–compression range between frequency shifts of the Al 2 O 3 R ‐lines and those of the 417 cm −1 Raman mode.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Pardo et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: