Answers are grounded in this paper and cite their sources.
Comparison of several effective medium theory methods was performed to describe the degradation of the elastic moduli of red sylvinite samples subjected to cyclic uniaxial compression with an increase in maximum load after each cycle. The predicted values of the Young’s modulus of red sylvinite after each loading cycle were determined using X-ray computed microtomography (CT data). The dependence of the deformation characteristics of red sylvinite on the maximum load in a cycle was experimentally determined. At loads up to 10 MPa, the tangent modulus of deformation changes insignificantly (≤10%); after a cycle with a load of 20 MPa, its significant degradation is observed, on average, by 32%. Analysis of CT data for sylvinite samples showed that microcrack formation begins in sylvinite conglomerates and at the boundaries with halite, and with increasing load, it spreads to halite conglomerates. It was found that the change in the tangent modulus of deformation of sylvinite linearly correlates with the volume fraction of microcracks. Two methods are proposed for estimating microcrack density from CT data: based on their maximum size and based on the radius of penny-shaped cracks of equivalent volume and lateral surface area. To describe the dependence of the effective Young’s modulus on the maximum load in a cycle, the following methods of effective medium theory were tested: the Mori–Tanaka method, the differential effective medium method, and the self-consistency method. It was established that the differential effective medium method and the self-consistency method with the crack density assessment by the first method give underestimated values of the average effective normalized Young’s modulus, starting from moderate loads, while the Mori–Tanaka method gives overestimated values. It is shown that the self-consistent method using the equivalent penny-shaped crack model to estimate the crack density gives acceptable results for predicting the effective Young’s modulus at a microcrack density of up to 0.5.
No takes yet. Share an insight, caveat, or question.
Panteleev et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: