Answers are grounded in this paper and cite their sources.
The effect of nuclear radiation on garnet film material parameters and bubble domain devices has been studied both during and after irradiation. The materials investigated include CVD grown Y3(FeGa)5O12, Er3(FeGa)5O12and LPE grown (YGdTm)3(FeGa)5O12films. The devices were different shift registers fabricated on ion implanted, non implanted and double layer YGdTmGaIG LPE films and GaErIG CVD films. Permanent damage on the material parameters caused by the irradiation were determined by measuring the4ₛ, σw, l, μw, Hc, Vₛand defect density before and after each irradiation, while the device performances were studied by comparing the propagation and annihilation margin and the detector signal. The irradiation sources included neutrons from a nuclear reactor and gamma rays from a Co60source. No significant Variation due to irradiation was found in any of the measurements for neutron irradiation up to 1015n/cm21 MeV equivalent and gamma irradiation up to 50 Mrads. Transient stability of information stored in a bubble memory was tested by writing information into different shift registers and then bombarding these registers with a high energy (∼1.5 McV) pulsed electron beam. The results indicate there is no loss of data for a dose rate of 104rads in a 30 ns pulse.
No takes yet. Share an insight, caveat, or question.
Chen et al. (1973) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: